Grizzly G0700 Owner's Manual page 26

17. Install the riving knife (Figure 22), using the
instructions on Page 32 as a guide.
Figure 22. Installing riving knife.
18. Insert the arbor lock tool into the hole shown
in Figure 23, rotate the arbor until the lock
tool seats, then install the scoring blade per
the instructions on Page 36.
Arbor
Lock
Tool
Figure 23. Installing scoring blade.
19. Slide the rip fence over until it just touches
the blade.
20. Adjust the mounting position of the round rail
until the rip fence evenly touches the entire
width of the blade from front to back.
Note: To adjust the mounting position of the
round rail, use the hex nuts (on the round rail
studs) that are on both sides of the tables.
-24-
21. Verify that the metal part of the rip fence does
Riving Knife
22. Check the height of the rip fence rail by slid-
23. Adjust the height of the rip fence rail, then
24. Re-install the large round washer on the end
not rest on the surface of the table.
Note: The rip fence body will scratch the
table surface if the ride height is not adjusted
correctly. Only the roller should touch the
table surface.
— If the rip fence body does not rest on the
table, then the fence is correctly adjusted.
— If the rip fence body does rest on the table,
carefully remove the rip fence and turn it
upside down. Loosen the set screw shown
in Figure 24 and rotate the hex bolt to raise
the roller. Tighten the set screw to lock the
ride height and recheck how the rip fence
rests on the table.
Roller
Figure 24. Rip fence height adjustment.
ing the rip fence along the rail and comparing
the gap between the rip fence body and the
tables.
tighten all of the hex nuts to secure the round
rail in place.
of the fence rail to prevent the fence body
from sliding off when moved backward.
Model G0700 (Mfd. Since 5/14)
Set Screw
Hex Bolt