Dust Collection; Power Connection - Grizzly G0700 Owner's Manual

Dust Collection

This machine creates substantial amounts
of dust during operation. Breathing air-
borne dust on a regular basis can result in
permanent respiratory illness. Reduce your
risk by wearing a respirator and capturing
the dust with a dust collection system.
NOTICE
Minimum CFM at 4" Dust Port: 400 CFM
Minimum CFM at 2 ⁄
1
2
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.
To connect dust collection hoses:
1.
Secure a 4" dust hose to the dust port located
under the saw table and the 2
the blade guard (see Figure 28).
2 ⁄ " Hose
1
2
Figure 28. Dust hoses attached.
-26-
" Dust Port: 150 CFM
⁄ " dust hose to
1
2
4" Hose
2.
Run the 2½" hose over the hose support, as
shown in Figure 29.
Figure 29. Dust hose support in use.
Tip: The two dust ports can be connected
together at the machine with the optional
Grizzly accessory shown in Figure 30.
H1215 4" Quick Fit Sleeve
T20559
2 ⁄ " x 4" x 4"
1
2
Y-Fitting
Figure 30. Consolidating dust lines with optional
dust collection accessories from Grizzly.

Power Connection

Before the machine can be connected to the
power source, an electrical circuit must be made
available that meets the minimum specifications
given in Circuit Requirements on Page 12. If
a power circuit has not been prepared for the
machine, do that now. To ensure a safe and code-
compliant setup, all electrical work MUST be done
by an electrician or qualified service personnel.
Model G0700 (Mfd. Since 5/14)