Grizzly G0700 Owner's Manual page 24

6.
The fence rail is pre-assembled with four rail
studs and accompanying hardware. Remove
one hex nut, flat washer, and lock washer
from the end of each stud, as shown in
Figure 13.
Figure 13. Hardware removed from fence rail
studs to prepare for installation.
7.
Install the rail with the studs through the holes
in the tables, as shown in Figure 14, and use
the hardware removed in the previous step to
secure the rail to the tables.
Do not tighten the hex nuts at this time,
because the rail still needs to be adjusted.
Large Round
Washer
Figure 14. Round rail installed.
8.
Remove the large round washer attached to
the end of the fence rail. With this washer out
of the way, you will be able to slide the rip
fence base onto the rail.
-22-
Stud
9.
Slide the rip fence base onto the round rail.
Thread the handles and knob into the rip
fence base, where shown in Figure 15.
Clamping
Plate
Knob
M10-1.5 x 55
Figure 15. Rip fence handles.
10. Slide the rip fence onto the rip fence base
by sliding the fence T-slot over the clamping
plate (see Figures 15-16). Lock the fence by
tightening the fence lock handle.
Figure 16. Installing the rip fence.
Model G0700 (Mfd. Since 5/14)
Handles
M10-1.5 x 12
Fence Lock
Handle
T-Slot for
Clamping Plate