Move Operations - GEM GPS3600 Owner's Manual

Move operations

Use the Move command to shift a file from one
location to another within the same device, or from
the Hard Disk to floppy (bypassing the RAM) and
vice versa. This option cancels the file at the
source.
WARNING - Use the Move function only in cases
where the original file needs to be cancelled.
To move a file from one floppy disk to another,
first load the file to RAM, then save it to the other
floppy.
Move operations are executed using the same
procedures are those described for the Load and
Save commands. This section provides general
information relating to the Move operation. The
user is encouraged to apply the same logic to
Move operations as those used for Load and
Save operations.
The example which follows shows how to use
the Move operation within RAM: Move Single
Sound.
MOVE SINGLE SOUND
1. Press DISK to enter Disk Mode and use the
+/– Page/Bank buttons to open the main
MOVE page.
2. Select the MOVE command required from the
main MOVE page.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
4•20 Reference Guide
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
3. Select the source and destination devices with
soft buttons F1, F2 or F3.
In this case, select RAM as the device to work
in.
Selecting «Floppy disk» or «RAM» automati-
cally assigns the same device to source and
destination.
4. Press ENTER to enter the file selector, select
a Block containing the desired file then press
ENTER to access the Block.
5. Select the File to Move from the source di-
rectory.
○ ○