4.6.4.
Transmission Problems
Does the ID display?
Does the Verification Stamp
operate?
Is the copy quality OK?
Any other problems?
START
No
Yes
No
Yes
No
Yes
Yes
No
END
1. No ID function at the remote unit.
2. The ID is not set for the remote unit.
1. Set "STAMP=ON"
2. Check CN3 (SC PCB).
3. Replace the Stamp Solenoid.
4. Replace the SC PCB.
Make a copy and refer to Sect. 4.4.
See Sect. 4.3. (Troubleshooting with the
Information Codes).
124