Panasonic UF-580 Service Manual page 53

3.4.7. Updating the UF-790 Firmware from V1.04 to V2.xx Only
I PC → Host
Printer Cover
Control Panel Unit
(2)
(3)
I Card → Host
Memory Card
Cover
(3)
Memory Card
(4)
(2)
(2)
Printer Cover
(1) Unplug the Power Cord.
(2) Open the Control Panel Unit and the Printer
Cover.
(3) Activate the Read-Point Sensor with your finger
as shown and plug in the Power Cord.
(4) Wait about 10 seconds, then release the Read-
Point Sensor and close the Control Panel Unit.
(5) Start the Firmware Programming Wizard and
proceed with downloading the firmware code to
the unit.
(6) Once the firmware code is reprogrammed in the
unit, it will reboot automatically and return to
standby.
(7) Perform Parameter Initialization.
(1) Unplug the Power Cord.
(2) Open the Printer Cover.
(3) Remove the Memory Card Cover.
(4) Insert the Flash Memory Card gently into the
card slot with the Panasonic logo facing to the
outside of the machine.
Caution:
Installing the Flash Memory Card in the wrong
direction may damage the connecting pins
inside the machine.
53