Panasonic UF-580 Service Manual page 145

No. Parameter
070 LINE ERROR
071 TOTAL ERROR 1 = 5%
072 CONTINUOUS
ERROR
073 ERROR
DETECT
074 RTN RECEIVE
075 CODING
076 Not Used
077 RX JAM
LENGTH
078 Not Used
079
080 DOC. TOP
FEED
081 DOC. END
FEED
082 JAM LENGTH
083 Not Used
084 LINE AS NO
PAPER
085 Not Used
086 REDUCTION
FINE
087 DARKER LEVEL 0 = Lightest Contrast
088 NORMAL LEVEL
089 LIGHTER LEVEL
Function Parameter Table
Selections
1 = 128 lines
2 = 256 lines
3 = 512 lines
4 = 1024 lines
5 = 2048 lines
6 = Off
(will not disconnect line)
2 = 10%
3 = 15%
4 = 20%
1 = Off (unlimited)
2 = 3 lines/STD
3 = 6 lines/STD
4 = 12 lines/STD
1 = Lines
2 = Rate
1 = Disconnect
2 = Continue
1 = MH (MH only)
2 = MR (MH or MR)
3 = MMR
(MH or MR or MMR)
1 = Off (unlimited)
2 = 2 m
3 = 8 m
-5.0 mm
~
+5.0 mm
-5.0 mm
~
+5.0 mm
1 = 1 m
2 = 2 m
3 = 8 m
4 = Unlimited
1 = Ring (ring)
2 = Busy (keep line busy)
1 = Off
2 = On
~
15 = Darkest Contrast
1. Selects the line disconnect condition during
reception. If the number of line errors exceed this
setting, the unit will disconnect the line.
2. Selects the transmit condition of RTP/PIP or RTN/
PIN.
(Available if No.73 Error Detect is set to "LINES")
(See Note 1)
Selects the transmit condition of RTP/PIP or RTN/
PIN.
(Available if No.73 Error Detect is set to "RATE".)
(See Note 2)
Selects the continuous total error criteria of Off/3/6 or
12 lines in Standard mode. If continuous total error
exceeds this setting, the unit will transmit RTN/PIN.
(Available if No.73 Error Detect is set to "RATE".)
Selects the error detect condition Lines/Rate.
Selects whether to disconnect the phone line or
continue when "RTN" is received.
Selects the coding scheme.
Selects the maximum length of a received document
that can be printed.
Adjusts the distance between the scanning sensor
ON position and the scanning start position.
Adjusts the distance between the scanning sensor
OFF position and the scanning end position.
Selects the maximum length of the original that can
be scanned.
Selects whether to ring or send a busy tone to the
remote station when the recording paper runs out or
the unit cannot receive because of any trouble.
Selects whether the resolution is preset to Fine,
when sending with reduction B4→A4.
(For B4 Scanning Model only)
Selects the contrast level.
→15
0←
Lightest← →Darkest
145
Function