Care And Cleaning - Fisher & Paykel OB30 Series User Manual

Care and cleaning

36
Removing and replacing the sliding shelves and side racks
To remove a sliding shelf, grip it by its two front corners (making sure you are gripping the wire
1
shelf and the sliding frame together), tilt upwards and pull it out of the oven.
To remove the side racks, gently push the retaining wire from underneath the lock stud, then
2
swing the lowest edge of the side rack up and out towards the center of the oven until the rack
is almost horizontal. The prongs at the top will slide out of the mounting slots.
To replace the side racks, hold them almost horizontally and locate the prongs into the small
3
mounting slots at the top of the oven cavity. While you are doing this, support the rack with your
hand from underneath, to ensure that both prongs perfectly locate into the mounting slots.
Lower the side racks carefully and gently place the retaining wire underneath the lock stud.
4
Important!
Do not lower the side racks until the prongs are fully inserted into the slots so that you do not chip the
enamel.
Lock stud
Retaining wire
Mounting slots