Wall Switch Installation For Fan - Hearth and Home Technologies BE-32 Owner's Manual

E. Wall Switch Installation for Fan (Optional)
If the box is being wired to a wall
mounted switch for use with a fan (See
Figure 10.4):
• The power supply for the appliance
must be brought into a switch box.
• The power can then be supplied from
the switch box to the appliance using
a minimum of 14-3 with ground wire.
• At the switch box connect the black
(hot) wire and red (switch leg) wire to
the wall switch as shown.
• At the appliance connect the black
(hot), white (neutral) and green
(ground) wires to the junction box as
shown.
• Add a 1/4 inch insulated female con-
nector to the red (switch leg) wire,
route it through the knockout in the
face of the junction box, and connect
to the top fan switch connector (1/4
inch male) as shown.
38
Figure 10.4 Junction Box Wired to Wall Switch
Hearth & Home Technologies • BE-32 • InD • 2099-985 Rev. C • 9/06
MINIMUM 14-3 AWG
WITH GROUND
Red
JUNCTION BOX
Red
Black Black
White
White
Green
SWITCH BOX
SWITCH
Green
POWER
SUPPLY WIRES