Junction Box Installation - Hearth and Home Technologies BE-32 Owner's Manual

BLK
BLK
BLK
TEMPERATURE
SENSOR SWITCH
Figure 10.2
D.

Junction Box Installation

If the box is being wired from the OUTSIDE of
the appliance:
• Remove the cover plate located on the outer
shell - right side (see Figure 10.3).
• Install the supplied Romex™
cover plate.
• Feed the necessary length of wire through the
connector.
• Make all necessary wire connections and reat-
tach the cover plate to the outer shell.
If the box is being wired from the INSIDE of the
appliance:
• Remove the screw attaching the junction box/
receptacle to the outer shell, rotate the junction
box inward to disengage it from the outer shell
(see Figure 10.3).
• Pull the electrical wires from outside the ap-
pliance through this opening into the valve
compartment.
• Feed the necessary length of wire through the
connector.
• Make all necessary wire connections to the
junction box/receptacle and reassemble the
junction box/receptacle to the outer shell.
VARIABLE SPEED CONTROL
JUNCTION BOX
BLK
BLK
BLK
BLK
110-120 VAC
connector in the
Hearth & Home Technologies • BE-32 • InD • 2099-985 Rev. C • 9/06
BLK
BLK
WHT WHT
GROUND
GRN
WHT
Figure 10.3 Junction Box Detail
NOTE: IF ANY OF THE ORIGINAL WIRE
AS SUPPLIED WITH THE APPLIANCE
MUST BE REPLACED, IT MUST BE
O
REPLACED WITH TYPE 105 C RATED WIRE.
BLOWER RECEPTACLE
Romex
Connector
14/2WG
Cover Plate
outside firebox
Copper
ground attached
GRN wire
to GRN screw with
inside box
GRN wire
NOTE: Do NOT wire
110VAC to wall switch.
BLOWER
37