Positioning The Logs - Hearth and Home Technologies BE-32 Owner's Manual

E. Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
1 1
Figure 12.2
CAUTION: Carefully remove the logs from the packaging.
Logs are fragile!
Figure 12.5
STEP 1.
LOG #1 (SRV2099-701): Place the left notch
on Log #1 over the back locating tab and rotate clockwise
until the right front hits the stop.
3 3
Figure 12.7
STEP 3.
LOG #3 (SRV278-702): Place the left side of
the log between the left grate tine and the side of the fi rebox.
Rotate log counter-clockwise until the back of the log rests
against the log locating tab.
3 3
2 2
1 1
Hearth & Home Technologies • BE-32 • InD • 2099-985 Rev. C • 9/06
Log Assembly: LOGS-BE32
Note: Arrows indicate log locating tabs.
Figure 12.3
Note: Arrow indicates notch in log #1.
Figure 12.4
Figure 12.6
STEP 2.
LOG #2 (SRV591-703): Place the "Y" of Log
# 2 in the far right grate tine and rotate clockwise until the
back of the log rests against the log locating tab.
2 2
2099-937
41