Threading For Twin Needle; Thread Sensor - Husqvarna Royale User Manual

THREADING FOR TWIN NEEDLE

Replace the sewing needle with a twin needle. Make
sure the presser foot is raised and the needle is in the up
position.
1. Raise the
Raise the
large spool cap and a felt pad on each one.
Place the thread spools on the spool caps.
thread slot and place the thread between
the
is on each side of the tension discs.
3. Thread down through the right-hand threading slot
and then upwards through the left-hand threading slot.
sure that one thread is inside the needle thread guide
threads do not become twisted together.
Note: The weight and irregular surface of specialty threads such as
metallic increases the amount of friction on the thread. By reducing
the tension, the risk of needle breakage and thread breakage is
reduced.

THREAD SENSOR

If the needle thread breaks or bobbin thread is running
low, the machine stops and a pop-up message appears on
the screen.
If needle thread breaks: Re-thread the machine and touch
you an opportunity to plan when you want to change your
bobbin. When the bobbin is replaced with a full one, touch
2:6
2 Set Up
Pre-Tension
C
D
A
B
E
E