Bobbin Winding - Husqvarna Royale User Manual

BOBBIN WINDING

BOBBIN WINDING THROUGH THE
NEEDLE
Make sure that the presser foot and the needle are in the up
position.
1. Place an empty bobbin on the bobbin spindle on
one way, with the logo facing up. Use only original
2. Thread the machine with the main spool pin in the
horizontal position.
Note: If the thread spool is too large to be in horizontal position,
wind the bobbin as described under "Winding Specialty Threads"
below.
foot and up to the right through
Note: Use a metal presser foot when bobbin winding from the
needle.
4. Guide the thread through the hole in the bobbin from
the inside to the outside.
5. Push the
adjust winding speed drag the slider with your stylus.
the excess thread.
Note: It is important that you cut the thread end close to the bobbin.
pop-up message closes.
the thread using the bobbin winding thread cutter.
WINDING SPECIALTY THREADS
We do not recommend winding speciality threads such as
stretchy threads, metallic or
threads through the needle.
1. Place an empty bobbin on the bobbin spindle at
one way, with the logo facing up. Use only original
2. Place the large spool cap and a felt pad under the spool
through
bobbins.
®
metallic
® bobbins.
Pre-Tension Thread guide
2 Set Up
A
Note: When using earlier version of HUSQVARNA VIKING
bobbins that do not have a hole, wind a few turns of thread clockwise
on the bobbin to get started.
B
C
®
D
2:7