Table of Contents
Advertisement
BOBBIN WINDING WHILE
EMBROIDERING OR SEWING
1.
Raise the auxiliary spool pin. Place the large spool cap,
felt pad and thread spool on the spool pin.
3.
Guide the thread through the hole in the bobbin from
the inside to the outside.
adjust winding speed drag the slider with your stylus.
starting to wind.
cut the thread using the bobbin winding thread cutter.
Note: Make sure that the thread does not touch the cap of the
horizontal spool pin when winding the bobbin. If it does, place the cap
and spool higher on the vertical spool pin.
INSERTING THE BOBBIN
2.
Place the bobbin in the bobbin case. It drops in only
one way with the logo facing up. The thread unreels
from the left of the bobbin. The bobbin will then
rotate counter-clockwise when you pull the thread.
2:8
2 Set Up
thread tension
1
3
A
D
C
E
B
2
4
G
F
Advertisement
Table of Contents
