Changing The Presser Foot - Husqvarna Royale User Manual

PRESSER FOOT

CHANGING THE PRESSER FOOT

1. Make sure that the needle is in the highest position.
Pull the presser foot down and towards you.
2. Line up the cross pin on the foot with the gap in the
presser foot ankle.
3. Push the foot into the clip until the foot snaps into
place.
ATTACHING THE SENSOR Q-FOOT
the needle into the opening of the foot by turning
the handwheel towards you. Position the foot onto
the presser foot bar so that the hole on the foot
matches the hole on the presser foot bar. The arm
of the presser foot should rest on top of the needle
screw. Insert the screw and tighten the screw with a
DUAL FEED WITH CHANGEABLE
PRESSER FEET
leathers and fabrics that need precise pattern matching.
the straight stitch in the center needle position with a stitch
when selecting stitches up to 7mm wide and 6mm long.
Accessories Included
2 Set Up
1
2
B C
A
D
A
2:9