Removing; Top Middle Cover - HP ProLiant DL160 Generation 5 Maintenance And Service Manual

Figure 9 Removing the Top Cover
To reinstall the top cover:
Align the top cover to the chassis and then slide it towards the front panel to position it into
1.
place.
Once the cover is attached to the chassis, tighten the captive screw on the rear panel with a T-15
2.
screwdriver.
Figure 10 Reinstalling the Top Cover

Top middle cover

To remove the top middle cover:
Loosen the four screws (one on each side of the chassis and two on the top middle cover) that
1.
secure the top middle cover to the chassis.
Lift the top middle cover away from the chassis.
2.
Contents 40