Figure 25 Fastening the non-hot-plug hard drive disk to the carrier
To install a non-hot-plug hard drive in the server:
Remove the hard drive blank from front of system if installed.
1.
Push the hard drive assembly into the drive bay until it stops.
2.
Fasten the screw with the T-15 wrench provided to secure the hard drive to the chassis.
3.
Connect the cabling from the HDD backplane to the drive using the cables provided.
4.
Figure 26 Installing the non-hot-plug hard drive assembly
To remove the non-hot-plug hard drive:
Loosen the screw with the T-15 wrench provided.
1.
Pull the hard drive assembly out of the drive bay.
2.
Contents 51