HP ProLiant DL160 Generation 5 Maintenance And Service Manual page 62

NOTE: Before installing the memory, remove the air baffle first, for detailed procedure, refer to the "
Processor" section in this chapter.
To remove memory module:
Completely open the holding clips securing the module.
1.
Gently pull the memory module upward to remove it from the slot.
2.
Figure 43 Removing a memory module
CAUTION: Place the memory module on a static-dissipating work surface or inside of an anti-static
bag.
To install a memory module:
Align the notch on the bottom edge of the module with the keyed surface of the DIMM slot and
1.
then press the module fully into the slot.
Firmly press the holding clips inward to secure the memory module in place.
2.
Figure 44 Installing a memory module
Contents 62