HP ProLiant DL160 Generation 5 Maintenance And Service Manual page 65

Figure 48 Removing the PCI cage
Installing PCIe/PCI-X riser boards
The system supports up to two riser boards at a time. Use only HP supported expansion boards that
meet the following specifications:
•
Compliance
○
PCI Express x16
○
PCI-X(available only when the optional PCI-X riser board is installed)
•
Form Factor
○
Low-profile
○
Full-Height/Full-Length
To remove the PCIe Riser card:
Loosen the two screws securing the riser card to the PCI cage.
1.
Push the riser card down and away from the PCI cage.
2.
Contents 65