HP ProLiant DL160 Generation 5 Maintenance And Service Manual page 92

Table 12
POST Error Messages
Error-Code Error Message
606 System Fan 4 Missing
607 System Fan 5 Missing
608 System Fan 6 Missing
60F Fan Solution Not Sufficient!
Critical Failure Detected –
System Shutting Down in 15
Second!
601 BMC Not Responding
05E Password check failed
Checking NVRAM Update
Failed
Operating system not found
611
System Event Log full
601
Error: BMC Not Responding
Description / Corrective Action
System fan 1 is not installed, user should install the system
fan. The system will shut down.
System fan 1 is not installed, user should install the system
fan. The system will shut down.
System fan 1 is not installed, user should install the system
fan. The system will shut down.
The non-redundancy fan is not installed, user should install the
system fan. The system will shut down
BMC not responding, you can load the optimal default value,
or you must change the LO100 card.
If user input incorrect password more than three times, then
display this error information and continue to boot. There are
two 'password checked failed'. 05E for setup password.
BIOS could not write to the NVRAM block. This message
appears when the FLASH part is malfunctioning.
Operating system cannot be located on any of the
boot drives.
Verify that the priority boot drive has power and that
the IDE cable is connected properly.
Verify that the desired boot drive has power
Verify that the IDE cable is securely plugged into the
respective system board connectors.
Verify that the boot device is enabled in the Setup
Utility.
Verify that the boot device has an operating system
installed.
If the problem persists, contact your Foxconn
Customer Support provider
You must enter BIOS SETUP UTILITY and then Clean the
System Event Log
BMC not responding, you can load the optimal default value,
or you must change the LO100 card.
Contents 92