EverFocus ENVR8304X 04CH User Manual page 96

Auto Lock: Check the box and the events will be recorded in a write protected segment of the
hard disk (will not be overwritten). The NVR will lock a period of time when the alarm occurs.
The length of the time depends on NVR setting (see 6.4.2 Lock / Format).
FTP Upload: Check the box to enable uploading recordings to the FTP server function. To setup
the FTP server, please refer to 6.6.4 FTP.
FTP Upload File Type: Select MP4 file type to upload 10-second videos to FTP server; select
JPEG file type to upload snapshots to the FTP server.
Alarm Output: Select an alarm output number. When an alarm is triggered, the signal will be
transmitted through the selected alarm output relay.
Output Type: Select an output type when an alarm is triggered.
Timeout: Select this option and then set up the Timeout Duration in the field below, the
alarm output will last for the setup duration time (10 ~ 150 seconds).
Permanent: Alarm will remain active until the user presses the "Enter" key on the IR Remote
Control or resets the alarm remotely.
Transparent: Alarm output remains as long as the alarm input is active.
Trans + Timeout: Alarm output continues until event ends, then continues for the setup
duration time (10 ~ 150 seconds).
Timeout Duration: This function only appears when you select Timeout or Trans + Timeout
options in the Output Type drop-down list. Select a duration time for the motion event. The
alarm output will last for the setup duration time between 1 and 150 seconds.
Main Monitor: Select Full Screen to force the camera associated with the selected alarm
number to display full screen on the Main Monitor. The full screen camera view will last
according to the Output Type selected in the field above.
Record: Select a camera to start recording when the associated alarm number is triggered.
Input Type: Select an input type when the selected alarm number is triggered. The options
include N.O. and N.C.
Active Camera: This function is for associating an alarm trigger with a specific camera. For
example, if you set up an external motion detector near Camera 2, you can select Camera 2 in
this field. The alarm will be associated with this camera for full screen display, event logging and
PTZ actions.
PTZ: If the Active Camera selected above is a PTZ camera, you can further set up the PTZ actions
in this field.
Apply To: Click the button to apply the same settings to the desired cameras.
87
ECOR HD 16X1 DVR