Direct High-Speed Connection - EverFocus ENVR8304X 04CH User Manual

2.5.2

Direct High-Speed Connection

In a Direct High-Speed Connection, the NVR connects directly to a modem without the need
for a router. You need to set the static or dynamic WAN IP address assigned by your ISP
(Internet Service Provider) in the NVR's configuration web pages. To access the NVR, just type
"http://xxx", where xxx is the IP address given by your ISP. If you have a dynamic IP address,
this connection may require that you use DDNS for a reliable connection.
Connection Procedure:
The first step is to purchase or make a straight through cable. We recommend

purchasing one if you have never made a straight through cable. Please remember you
can not use a cross-over network cable for this application
Once you have a straight through cable plug one end into the LAN port on the back of

the recorder and the other into the high speed modem.
Log into the EverFocus NVR menu and go to the Network Setting Menu.

Input the Static IP address, the Subnet Mask, and the Gateway that you obtained from

the internet service provider.
Note: If you have a dynamic IP address, you can set the NVR to DHCP to automatically
detect the network settings. Therefore, it can use a dynamic IP address.
Exit from the NVR's Menu to save the settings.

To access the NVR from a computer, open Internet Explorer and in the address bar type:

http:// (IP address given by your internet service provider)
Note: When using this type of connection, only one device can be connected to the
modem at a time. You will need to use a computer at a different location to test the
connection s.
27
ECOR HD 16X1 DVR