Setting The Inspection Area - Panasonic MICRO-IMAGECHECKER AX40 User Manual

4.4.3 Setting the Inspection Area

The ways to set the position or size of the area for executing inspection are described below. There are
several shapes of the areas including Rectangle, Circle and Polygon, Line and Area.
Drawing a Rectangle and Line
Follow the steps below after displaying a checker area on the screen by selecting "Change".
1. Move the whole rectangle.
Move the circle by tilting the ENTER key in the desired direction
and press the ENTER key to fix the position
2. Fix the start point (the white square mark on the rectangle).
Move and position the start point by tilting the ENTER key in the desired
direction. Press the C key to go back to the previous step.
3. Set the end position (the black square mark on the rectangle) of
the circle.
Move and position the start point by tilting the ENTER key in the desired
direction. Press the C key to go back to the previous step.
40