Position Adjustment (Gray Edge) - Panasonic MICRO-IMAGECHECKER AX40 User Manual

6.13 Position Adjustment (Gray Edge)

6.13.1 Setting Procedure
The procedure for detecting and setting the object is the same as that for "Gray Edge". (See page 86). In
this section, the differences are described below.
Detection Position
Position Adjustment (Gray Edge) cannot set "Detection Position". Always detects the nearest edge from
the start point.
Priority
The Priority function is effective if an object moves largely either in the vertical direction or in the
horizontal direction. When the object moves largely in the horizontal direction, set to "Horizontal". When it
moves largely in the vertical direction, set to "Vertical".
Testing Horizontal and Vertical Areas
Before registering a base position, you can perform a test to check if Horizontal/Vertical Areas can detect
an edge. When a live image is currently displayed, import a new image and begin to test. When a
Memory image is displayed, test with the Memory image currently displayed without importing any
images.
1. Select "POS. ADJ. (GRAY EDGE).
2. Press the A key while the tab or each item is highlighted.
If no edge is detected, the following error code appears in the message area.
E0044
Check to make sure that the error code above does not appear or that the edges are detected.
• You cannot assign different memories to the horizontal and vertical areas.
Wrong example:
Horizontal area=memory 1, Vertical area=memory 2
• You can assign different groups to the horizontal and vertical areas.
Correct example:
Horizontal area=group A, Vertical area=group B
120