6.15 Position Adjustment (Matching)
6.15.1 Setting Procedure
Follow the same steps that were used for "Smart Matching" to detect and set an object. (See page 100).
In this section, the differences are described below.
Items you cannot set
The Position Adjustment (matching) function does not set the following feature data.
• Subtraction setting (Subtraction can not be performed.)
• Rotation Angle Range
• Rotation Accuracy
Testing
Before registering a base position, you can perform a test to check if Horizontal/Vertical Areas can detect
an edge. When a live image is currently displayed, import a new image and begin to test. When a
Memory image is displayed, test with the Memory image currently displayed without importing any
images.
1.
Select "POS. ADJ (MATCHING)".
2.
Press the A key while the tab or the item is highlighted.
If no edge was detected, the error code "E0044" will appear in the message area.
E0044
Check the image to make sure that the error code above does not appear or that the object is detected.
126