Activate The Software Packages - GE ApexPro Service Manual

Upgrading ATS software

Activate the software packages

B-8
NOTE
If you selected more than one software package to be installed on the
targeted ATSs, each package is installed in sequential order.
A software package can only be installed on a limited number of target
devices at the same time. As a result, the software install may occur in
sequential groupings.
3. To cancel a software install, select Cancel.
NOTE
Selecting Cancel only cancels the installation of the Queued software
packages identified in the Transfer Status window. Once the installation of a
software package has started, you cannot cancel it.
4. To save the list of displayed IP address in a .txt file format, select File > Export
IP File. Specify the destination and file name of this .txt file.
5. Verify the status of all software packages indicate Success.
6. Select Exit.
WARNING
LOSS OF MONITORING — This procedure requires you to reboot
the ATS. Rebooting an ATS stops active patient monitoring. When a
care unit has only one working ATS, notify the site's biomedical
department to provide alternate bedside patient monitoring.
Establish alternate monitoring methods on page B-3.
ApexPro™ Telemetry
659A
See
2001989-203C