Cd Rom Drive; Complete The Preparation Procedures - GE ApexPro Service Manual

Parts lists, drawings and replacement

CD ROM drive

7-22
NOTE
The rebuild procedure takes approximately 45 minutes.
1.

Complete the preparation procedures.

7-3.
2. Remove the chassis cover.
3. Remove the drive bay.
4. Using a phillips screwdriver, remove the 4 anchor screws securing the CD/hard
drive carrier in the drive bay on both sides.
5. Slide the CD/hard drive carrier out of the front of the drive bay.
6. Using a phillips screwdriver, remove the 2 screws securing the left side of the CD
ROM drive into the CD/hard drive carrier.
7. Using a phillips screwdriver, remove the 2 screws securing the right side of the
CD ROM drive into the CD/hard drive carrier.
ApexPro™ Telemetry
See Field replacement preparation on page
See Chassis cover on page 7-6.
See Drive bay on page 7-16.
018A
160A
063A
2001989-203C