Start The Software Transfer Utility - GE ApexPro Service Manual

Windows XP

Start the software transfer utility

2001989-203C
3. Under Components checked are used by this connection, scroll down and
highlight Internet Protocol (TCP/IP) and select Properties. The Internet
Protocol (TCP/IP) window displays.
4. Select the Use the following IP address option and complete the following steps:
a. In the IP address field, type an IP address that is not used at this site.
b. In the Subnet mask field, type the Subnet mask address. The address must
match the Subnet mask address used at this site.
5. Select OK to save this configuration and close the Internet Protocol (TCP/IP)
window.
6. Select OK to close the Local Area Connection Properties window.
1. From the Windows taskbar, select Start > Control Panel > Network
Connections.
2. Right-click Local Area Connection.
3. Select Properties.
4. Select Internet Protocol (TCP/IP).
5. Select Properties.
6. Select Use the following IP address.
7. Type IP address and subnet mask and default gateway values matching the Unity
Network IX network domain for the ATS. For example:
IP Address: 192.168.x.x
Netmask: 255.255.0.0
8. Select OK.
9. Select OK.
10. For Windows XP, instead of restarting the service laptop, you can select Start >
Control Panel > Network Connections, right-click on Local Area Connection,
select Disable and then right-click again and select Enable.
Insert the CD containing the software packages into the service laptop's CD
drive. After approximately one minute, the GE Healthcare Software Transfer
Utility window automatically displays on the laptop's display.
NOTE
If the GE Healthcare Software Transfer Utility does not automatically
display, navigate to the contents of the CD and double-click the auto.bat file.
ApexPro™ Telemetry
Upgrading ATS software
B-5