Accessories - Rangemaster Professional+ FX 90 Dual Fuel User's Manual & Installation Instructions

ArtNo.301-0007 2BC
Fig. 2.31
Stopping the oven 1
A
Fig. 2.32
C
A
Fig. 2.33
Art No. 301-0011 2BC
Activating the key lock 1
C
A B
Fig. 2.35
ArtNo.326-0013 - Full capacity shelf
(Falcon)
Fig. 2.37
ArtNo.331-0008 - 90SC
grill pan & trivet
Fig. 2.39
Fig. 2.41
ArtNo.320-0031 90SC
removing the shelf 1
D
B
ArtNo.301-0007 2BC
Stopping the oven 1
B
Fig. 2.34
ArtNo.301-0012 2BC
Activating the key lock 2
C
A
Fig. 2.36
ArtNo.326-0004 - Cradle shelf
Fig. 2.38
ArtNo.326-0015 - Energy saving shelf (Falcon)
Fig. 2.40
ArtNo.281-0028 - Albertine divider
Fig. 2.42
ArtNo.320-0032 90SC
removing the shelf 2
symbol on the display will disappear and the word
'AUTO' will flash (Fig. 2.31).
7. Once the specified time has elapsed it will emit an alarm.
There are two ways to cancel the alarm refer to Cancel
the Timer Alarm page 8:
Reset to Manual Cooking
To cancel any automatic settings turn the Timer (A) knob to
the Clock (C) setting and release (Fig. 2.32).
Key Lock
The Key Lock will activate and deactivate the oven.
1. Cancel any active programs. Refer to Reset to Manual
Cooking page 10.
2. Turn the Timer (A) knob to the Clock (C) setting and hold
for approx 8 seconds. The display will show 'ON' (Fig.
2.33).
3. Continue to hold the Timer (A) knob onto the Clock (C)
setting, turn the Adjusting (B) knob clockwise, the 'OF'
and the 'Key' symbol will display (Fig. 2.34). The oven is
now locked.
B
4. To activate repeat steps 1 to 2 and continue to hold
the Timer (A) knob onto the Clock (C) setting, turn the
Adjusting (B) knob clockwise to 'ON', the 'Key' symbol
will disappear and the oven is enabled.

Accessories

Each oven is supplied with:
• Two full capacity shelves (Fig. 2.35)
Grill pan tray support (Fig. 2.36)
•
Two grill pans with trivets (Fig. 2.37)
•
Three energy saving shelves (Fig. 2.38)
•
• Four ladder shelf supports (Fig. 2.39)
And one divider (Fig. 2.40)
•
Oven Shelves
Any shelf can be fitted in any of the positions. The oven
shelves are retained when pulled forward but can be easily
removed and refitted.
To Remove and Refit the Ladder Shelf Supports
Lift the ladder support hooks out of the two locating holes in
the oven side (or divider) before lifting the support clear of
the bottom ladder restraint.
Refit by inserting the bottom of the ladder into the restraint
before fitting the hooks through the locating holes.
To Remove and Refit the Shelves
Pull the shelf forwards until the back of the shelf is stopped
by the shelf support (Fig. 2.41). Lift up the front of the shelf
so the back of the shelf will pass between the supports and
then pull the shelf forward (Fig. 2.42).
Refit in the reverse order, making sure to push it fully back.
10