Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Positioning the Cooker
The diagrams show the minimum recommended distance
from the cooker to nearby surfaces (Fig. 7.1 and Fig. 7.2).
The cooker should not be placed on a base.
Above hotplate surround should be level with, or above,
any adjacent work surface. A gap of 75 mm should be left
between each side of the cooker ABOVE the hotplate level
and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25 mm.
A minimum space of 650 mm is required between the top of
the hotplate and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer's instructions.
**Any splashback must be fitted in accordance with the
manufacturers instructions. Allowance should be made for the
additional height of the flue trim, which is fitted to the cooker
hob.
We recommend a gap of 905 mm between units to allow for
moving the cooker. Do not box the cooker in – it must still
be possible to move the cooker in and out for cleaning and
servicing.
Moving the Cooker
On no account try and move the cooker while it is
n
n
plugged into the electricity supply.
The cooker is very heavy, so take great care.
n
n
We recommend two people manoeuvre the cooker. Make
sure that the floor covering is firmly fixed, or removed to
prevent it being disturbed when moving the cooker around.
To help you, there are two levelling rollers at the back and
two screw-down levelling feet at the front.
Removing the Oven Door
To remove the oven door, open the door fully. Swivel the
locking 'U' clips forward to the locking position (Fig. 7.3). Grip
the sides of the door, lift upwards and then slide the door
forwards (Fig. 7.4).
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig. 7.5). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
INSTALLATION
ArtNo.092-0005 - 90DF SC min positions above cooker
410 mm min
2.5 mm
ArtNo.325-0002 - BI oven removing the door
21
ArtNo.092-0003 - 90SC cooker min spacings
75 mm
min
650 mm
min
900 mm min*
**
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig. 7.1
75 mm
min
905 mm min
930 mm max
Fig. 7.2
2.5 mm
Fig. 7.3
Fig. 7.4
Fig. 7.5
Advertisement
Table of Contents
