Basic Call Features - Yealink SIP-T20P Quick Start Manual

Basic Call Features

Placing a Call
Using the handset:
1. Pick up the handset.
2. Enter the number, and then press
Using the speakerphone:
1. With the handset on-hook, press
2. Enter the number, and then press
Using the headset:
1. With the headset connected, press
2. Enter the number, and then press
Note: During a call, you can alternate between headset, hands-free speakerphone and handset modes by pressing
the HEADSET key, the Speakerphone key or by picking up the handset. Headset mode requires a headset connected.
Answering a Call
Using the handset:
Pick up the handset.
Using the speakerphone:
Press .
Using the headset:
Press .
Note: You can reject an incoming call by pressing the X key.
Ending a Call
Using the handset:
Hang up the handset or press
Using the speakerphone:
Press or .
Using the headset:
Press .
Redial
Press to enter the placed calls list, press
.
Press twice when the phone is idle to dial the last dialed number.
Call Mute and Un-mute
Press to mute the microphone during a call.
Press again to un-mute the call.
Call Hold and Resume
To place a call on hold:
Press during an active call.
To resume the call, do one of the following:
If there is only one call on hold, press
.
.
.
to activate the headset mode.
.
.
or
.
to select the desired entry, and then press or
4