U-Line 3045CLR Quick Start Manual
U-Line 3045CLR Quick Start Manual

U-Line 3045CLR Quick Start Manual

Modular 3000 series
Hide thumbs Also See for 3045CLR:

Advertisement

Quick Links

QUICK START GUIDE
Modular 3000 Series
3045CLR
220-240 V / 50 Hz

Advertisement

Table of Contents
loading

Summary of Contents for U-Line 3045CLR

  • Page 1 QUICK START GUIDE Modular 3000 Series 3045CLR 220-240 V / 50 Hz • •...
  • Page 2 1. U-Line Customer Care must be contacted immediately at +1.800.779.2547. 2. Service or repairs performed on the unit without prior written approval from U-Line is not permitted. If the unit has been altered or repaired in the field without prior written approval from U-Line, claims will not be eligible.
  • Page 3: Table Of Contents

    QUICK START GUIDE u-line.com Contents Model List Safety and Warning Environmental Requirements Electrical Water Hookup Drain Door Swing General Installation Integrated Panel Installation Control Quick Guide First Use Sabbath Mode Warranty...
  • Page 4: Model List

    QUICK START GUIDE u-line.com Model List This guide provides the basics to get you started. Looking for more information? Visit u-line.com to view detailed User Guides for all U-Line products. Clear Ice Machines* U-3045CLRINT-00B U-3045CLRINT-40B *Unit shown with wood panel not included with unit.
  • Page 5: Safety And Warning

    QUICK START GUIDE u-line.com Safety and Warning that they do not play with this appliance. Cleaning and user maintenance shall not be performed by children without supervision. NOTICE PLEASE READ all instructions before installing, operating, or servicing the appliance. DANGER...
  • Page 6: Environmental Requirements

    This is considered normal. The condensation will evaporate when the humidity drops. Do not block any internal fans. CAUTION Use only genuine U-Line replacement parts. Imitation parts can damage the unit, affect its Damages caused by ambient temperatures of operation or performance and may void the 40°F (4°C) or below are not covered by the...
  • Page 7: Electrical

    PREPARE PLUMBING WARNING The water valve uses a standard 1/4" (6.35 mm) compression fitting. U-Line recommends using accessory SHOCK HAZARD — Electrical Grounding water hook up kit – part # WATERHOOKUP. The kit Required. Never attempt to repair or perform...
  • Page 8 QUICK START GUIDE u-line.com 3. Locate water CAUTION valve in the front of the unit and Do not use any plastic water supply line. The line thread water is under pressure at all times. Plastic may crack supply line or rupture with age and cause damage to your through.
  • Page 9: Drain

    2 cm drop per 100 cm) of run. CAUTION Drain line does not create traps and is vented per local If your U-Line unit did not come with a factory code. installed drain pump you must use a gravity style drain connection. For assistance in 1.
  • Page 10 P60 Pump Required requirements for a gravity drain, you may have ordered a Air Gap pre-installed U-Line P60 drain pump. (Optional Hook-Up) If you need to install a P60 drain pump into your unit, see DRAIN PUMP section in the User Manual.
  • Page 11: Door Swing

    QUICK START GUIDE u-line.com Door Swing 2. If the unit is not level, remove grille and adjust legs as necessary. Use included tool to adjust the height of the For models that are installed adjacent to a wall, 1/4" rear legs.
  • Page 12: Integrated Panel Installation

    6. Secure integrated panel to door using Clamp 1. Fully open door. clamps. A robust tape may also be used. U-Line 2. Starting at corner, pull recommends the gasket away from door. use of bar clamps Door/Drawer to secure the panel 3.
  • Page 13 QUICK START GUIDE u-line.com 9. Using a Phillips screwdriver, place one screw into each of the 6 pilot holes and screw down. Do not over tighten screws. 10.Ensure the screws sit flush against the bottom of the channel. Integrated Panel Integrated Panel 11.Remove clamps from door.
  • Page 14: Control Quick Guide

    Service menu Press and hold for 5 seconds Press to scroll through menu. First Use All U-Line controls are preset at the factory. Initial startup ICE CUBE THICKNESS ADJUSTMENT requires no adjustments. NOTICE NOTICE Ice thickness adjustment should only be made one increment at a time.
  • Page 15 QUICK START GUIDE u-line.com 12.7 mm) in depth. A fuller cube with less of a dimple ICE ADJUST results in a thicker ice bridge. As the ice bridge thickens, the tendency for the cubes to stay together as a slab Select increases.
  • Page 16: Sabbath Mode

    2. During the two year warranty period for all U-Line products, U-Line shall be responsible for the labor Select...
  • Page 17 5. U-Line products are designed to operate in ambient temperatures between 10°C and 32°C unless otherwise Warranty 6/2014 Rev.H noted in the product manual. Exposure to...

Table of Contents