Congratulations on your purchase of a U-Line refrigerator. warranty registration card. You may also register online at www.u-line.com For nearly five decades and three generations, U-Line continues to be the leader in innovation, quality and value in the premium built-in undercounter ice making, refrigeration and wine preservation market.
Table of Contents Safety Precautions Safety Alert Definitions ............................1 General Precautions .............................1 Product Features Ice Makers Feature: ..............................2 ADA15IM Model Features: ..........................2 Combo® Models Feature: ..........................2 CO1175 and BI2115 Model Feature: .......................2 BI2115 Model Features: ............................2 Product Operation Air Flow ...................................3 Initial Startup ................................3 Control Dial ................................3 Adjusting Air Temperature ..........................4...
WARNING U-Line Corporation direct. Consult the installation guide before any installation begins. U-Line contact SHOCK HAZARD - Electrical Grounding Required. information appears on the rear cover of this guide. • Never attempt to repair or perform maintenance on •...
Self-closing door. Engages when the door is open 8-10". Ensures a positive door seal and prevents door bounceback. Flat recessed grille. Blends with the other models and integrates with surrounding cabinetry. Contemporary grille design. Integrates seamlessly with surrounding cabinetry. Defrost Type: Manual Defrost For indoor use only. u-line.com...
Initial Startup Product Operation All U-Line controls are preset at the factory. Initial startup requires no adjustments. Air Flow NOTICE U-Line recommends allowing the unit to run overnight NOTICE before loading refrigerator or freezer with product. The unit requires proper air flow to perform at its highest efficiency.
• The number of door openings and the time the door is open. • The time the internal light is illuminated. (This mainly affects product on the top rack or shelf.) • The front grille or condenser are obstructed. Warmer Colder 3. Replace the front grille (two screws). u-line.com...
Remove the ice bucket for emptying and cleaning. To remove the ice bucket, raise the bin arm and remove the bucket from the ice compartment. Use the ice bucket for ice storage only. u-line.com...
The unit must be located on a level surface, for proper door and ice maker (if equipped) operation. Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1). u-line.com...
2. Carefully pull the shelf away from the door. To install the door shelf: 1. Holding the shelf in the center, center the shelf in the door at the desired location, slightly above the pins (2). 2. Lower the shelf onto the pins (2). u-line.com...
Plastic Plastic 2. Remove corresponding screws on opposite side of cabinet. On Plug Hole Plug Hole some models there may be a nut behind one or both screws on either side. Right Side Left Side Door Swing Door Swing u-line.com...
Page 12
Align and adjust the door: opposite of where it was removed. 1. Align and adjust the door, see DOOR ALIGNMENT AND 4. Remove the U-Line nameplate (3) from door. This will reveal ADJUSTMENT. mounting holes for the door actuator bracket.
U-CO1175S-00 ULN-SP18WH-03 U-CO1175S-01 ULN-SP18WH-20 U-CO1175S-20 U-CO1175S-22 U-CO29B-00 U-CO29B-03 2. Remove the top hinge pivot pin with a Phillips screwdriver and U-CO29B-20 lift door off bottom hinge pin. Be careful not to lose the door closer insert sets. 3. Turn the door upside down and inspect the hinge plate mounting holes.
1. Install the hinge just removed from the top to the BOTTOM opposite side of the cabinet (three screws) (2). 2. Remove the two door closer inserts (4) from the existing bottom hinge. 3. Install door closer inserts as shown on the new bottom hinge (4). u-line.com...
Page 15
4. Hold door to keep it from falling. 5. Reinstall hinge screw pin (1) into top hinge using a Phillips Bottom Of Door screwdriver. Align and adjust the door: Align and adjust the door, see DOOR ALIGNMENT AND ADJUSTMENT on page 10. Pivot Plate Screws u-line.com...
Page 16
(three screws) (2). 2. Remove the two door closer inserts (4) from the preexisting bottom hinge. Logo Door Orientation Left Hand Hinge 3. Install door closer inserts as shown on the new bottom hinge Logo (4). u-line.com...
Page 17
4. Hold door to keep it from falling. 5. Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver. Align and adjust the door: Align and adjust the door, see DOOR ALIGNMENT AND ADJUSTMENT on page 10. u-line.com...
Claire® Stainless Steel Polish and Cleaner, which can To defrost: be purchased from U-Line Corporation (Part Number 173348). Comparable products are acceptable. Frequent cleaning will 1. Disconnect power to the unit. remove surface contamination that could lead to rust. Some 2.
RISK OF CHILD ENTRAPEMENT. Before you throw away Typical Model Shown your old refrigerator or freezer, take off the doors and leave shelves in place so children may not easily climb inside. 3. Remove the cabinet door. Icemaker Models Typical Model Shown u-line.com...
DANGER Before Calling for Service ELECTROCUTION HAZARD. Never attempt to repair or If you think your U-Line product is malfunctioning, read the perform maintenance on the unit until disconnecting the OPERATION section of this guide to clearly understand the main electrical power.
E-mail: onlineparts@u-line.com BUILDING ON THREE GENERATIONS OF INNOVATION For over five decades and through three generations, U-Line continues to be the leader in innovation, quality and performance in the premium built-in undercounter ice making, refrigeration and wine preservation market. U-Line has captivated those with an appreciation for the finer things with exceptional functionality, style, inspired innovation and attention to even the smallest details.