Table of Contents
Advertisement
QUICK START GUIDE
Control Quick Guide
Actual Display:
Control Function Guide:
FUNCTION
OFF
ON
Adjust lighting
Customer menu
Service menu
First Use
All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends discarding the ice produced
during the first two to three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
When plugged in, the unit will begin operating under the
factory default setting. Follow the on screen prompt for
language selection and temperature units.
To turn the unit off, press
release. The display will show a countdown to switching the
unit off.
To power your unit on, simply press
immediately switch on.
Up
Down
COMMAND
Press
and hold
Press
and release
Press
to adjust lighting
Press
and hold for 5 seconds
Press
or
and hold for 5 seconds
and hold for 5 seconds and
and the unit will
ICE PRODUCTION
U-Select Lighting
DISPLAY/OPTIONS
Display will count down from 5 to off
Unit will come on immediately
Press
Press
Press
Ice
ICE CUBE THICKNESS ADJUSTMENT
NOTICE
Ice thickness adjustment should only be made
one increment at a time. Allow ice maker
production to stabilize for 24 hours before
rechecking ice thickness.
Remove all ice from the storage bin.
Ice cubes in any given batch will vary, so it is necessary
to choose cubes from the sample area for comparison
when making adjustments.
The ice cube thickness is factory set for best overall
performance. The factory setting "0" is designed to
maintain an ice bridge of approximately 1/16" to 1/8"
(1.6 mm to 3.2 mm) under normal conditions, resulting in
a dimple of approximately 1/4" to 1/2" (6.4 mm to
11
Zone Toggle
Select
Power
or
to set low, medium or high
or
to scroll through menu
or
to scroll through menu.
u-line.com
Advertisement
Table of Contents
