Advertisement
Assembly
1.
Carefully unpack units and lay the panels, viewing surface down,
on the clean work area (Figure 1).
Note: The middle panel will not have connecting bars.
2. Align the connecting bars of the side panels with the middle
panel. Evenly push each side panel into the middle panel.
Connection Bar
Side Panel
Panel Supports
#8 x 1/2" Screws
Tape
3. Insert (8) #8 x 1/2" screws through the middle panel at the
connecting bars. Each connecting bar will use (2) screws
(Figure 1a).
4. Apply a strip of black tape on each panel joint centered on the
panel supports (Figure 1b).
5. Raise assembly on edge by lifting one of the long sides to a
vertical position perpendicular with the floor. The side with the
Da-Lite badge on the middle panel must be closest to the floor.
Note: During Steps 6-9, the screen assembly will need to remain
in this vertical position.
Middle Panel
Figure 1a
Panel Supports
Figure 1b
Side Panel
Tape
3
Advertisement
