Advertisement
Quick Links
Advertisement
Related Manuals for Da-Lite Dual Masking Electrol
Summary of Contents for Da-Lite Dual Masking Electrol
- Page 1 INSTRUCTION BOOK FOR Dual Masking Electrol...
-
Page 2: Important Safety Instructions
Important Safety Instructions When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. -
Page 3: Pre-Installation
Pre-Installation Carefully unpack screen. 2. Make sure to recheck measurements of screen location before installation. 3. Remove center support brackets (on 8' and wider screens only), reverse brackets and reinstall flush with the top of the box Adjustment Mask Motor Knob “Down”... - Page 4 ATTENTION! Le masque ne doit pas être ajusté sur place pour régler la chute. Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use a screw driver or allen wrench to make adjustments.
- Page 5 ATTENTION! Le masque ne doit pas être ajusté sur place pour régler la chute. Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use a screw driver or allen wrench to make adjustments.
- Page 6 May be adapted for 1/4" paneling for ceiling. use with dropped ceiling. May also be adapted for use with acoustical or other ceiling 3/4" thick but cut to 1/4" thick under screen case and panel. Dual Masking Electrol Instructions ® 9" 8 11/16"...
-
Page 7: Troubleshooting
Troubleshooting Symptom Cause Solution Verify 115-125V (or 220-240V). If insufficient voltage, Incorrect line voltage. rewire incoming electric line. Blown fuse. Replace fuse. Tripped circuit breaker. Reset circuit breaker. Check above. Tighten all loose wire connections. Correct any improper connections. “Down” Position No power to operating switch or junction. - Page 8 OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE. In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137, Warsaw, IN 46581-0137, (574) 267-8101, (800) 622-3737.