Loading The Original Into The Adf - Muratec MFX-C2280 User Manual

5.1

Loading the Original into the ADF

d
Reference
If there are too many original sheets that cannot be loaded into the ADF at the same time, you can load them
in several batches and handle them as one job. For details, refer to "User's Guide [Copy Operations]/[Spec-
ifying the Original Size and Scan Method]".
For an original with pages of different sizes, you can collectively load them into the ADF, and scan data while
detecting the size for each page. For details, refer to "User's Guide [Copy Operations]/[Specifying the Original
Size and Scan Method]".
Loading the original into the ADF
The ADF feeds original sheets one by one in order from the top, and automatically loads them. It also loads
a 2-sided original automatically.
The ADF is helpful when loading a large number of original.
1
Widen the Lateral Guide.
2
Put the first page of an original at the top, and load the original
into the Original Tray with the required side facing upward.
% Load the original so that its top side is placed at the back.
When loading in a different orientation, be sure to specify
the loading direction of originals.
% For details on the loading direction of originals, refer to
"User's Guide [Copy Operations]/[Specifying the Original
Size and Scan Method]".
NOTICE
Do not load more than 100 sheets at a time into the Original
Tray, and do not load the sheets up to the point where the top
of the stack is higher than the , mark. Doing so may cause the
originals to jam, damage the originals and/or ADF failure.
However, if the original contains more than 100 pages, it can be scanned separately.
3
Slide the Lateral Guide to fit the loaded original.
Load the Original
5
5-3