Yamaha 2011 WR250FA Owner's Service Manual page 264

REMOVING THE BRAKE MASTER
CYLINDER
1. Remove:
• Brake master cylinder bracket "1"
• Brake master cylinder "2"
• Do not let the brake master cylinder hang
on the brake hose.
• Keep the brake master cylinder cap side
horizontal to prevent air from coming in.
REMOVING THE GRIP
1. Remove:
• Grip "1"
Blow in air between the handlebar or tube guide
and the grip. Then remove the grip which has
become loose.
CHECKING THE HANDLEBAR
1. Inspect:
• Handlebar "1"
Bends/cracks/damage → Replace.
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken the
handlebar.
INSTALLING THE HANDLEBAR
1. Install:
• Handlebar lower holder "1"
• Washer "2"
• Nut (handlebar lower holder) "3"
• Install the handlebar lower holder with its side
having the greater distance "a" from the
mounting bolt center facing forward.
• Apply the lithium soap base grease on the
thread of the handlebar lower holder.
• Installing the handlebar lower holder in the re-
verse direction allows the front-to-rear offset
amount of the handlebar position to be
changed.
• Do not tighten the nut yet.
6-37
HANDLEBAR