Yamaha 2011 WR250FA Owner's Service Manual page 206

Apply the sealant to the grommet of the AC
magneto lead.
YAMAHA Bond No. 1215 (Three-
®
Bond No. 1215):
90890-85505
3. Install:
• Idle gear 2 "1"
• Dowel pin "2"
Apply the engine oil on the idle gear 2.
4. Install:
• Idle gear plate "1"
• Bolt (idle gear plate) "2"
Bolt (idle gear plate):
10 Nm (1.0 m•kg, 7.2 ft•lb)
AC MAGNETO AND STARTER CLUTCH
5. Install:
• Washer "1"
• Bearing "2"
• Starter clutch drive gear "3"
• Washer "4"
Apply the engine oil on the washer, bearing and
starter clutch drive gear inner circumference.
E
6. Install:
• Starter clutch "1"
To rotor "2".
• Install the starter clutch with its plate side up-
ward.
• While installing the starter clutch, push in the
projections "a" one by one on the clutch cir-
cumference.
• Push in the starter clutch until it hits the rotor.
E
7. Install:
• Starter clutch assembly cover "1"
To rotor "2".
Install the starter clutch assembly cover by fit-
ting its pawls "a" into the groove "b" in the rotor.
5-73