Yamaha 2011 WR250FA Owner's Service Manual page 260

27.Install:
• Protector guide "1"
Install the protector guide with its wider side "a"
facing downward.
INSTALLING THE FRONT FORK
1. Install:
• Front fork "1"
• Temporarily tighten the pinch bolts (lower
bracket).
• Do not tighten the pinch bolts (upper bracket)
yet.
2. Tighten:
• Front fork cap bolt
Front fork cap bolt:
30 Nm (3.0 m•kg, 22 ft•lb)
3. Adjust:
• Front fork top end "a"
Front fork top end (standard) "a":
5 mm (0.20 in)
4. Tighten:
• Pinch bolt (upper bracket) "1"
Pinch bolt (upper bracket):
21 Nm (2.1 m•kg, 15 ft•lb)
• Pinch bolt (lower bracket) "2"
Pinch bolt (lower bracket):
21 Nm (2.1 m•kg, 15 ft•lb)
Tighten the lower bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
5. Install:
• Speed sensor lead "1"
• Plate 1 "2"
• Bolt (plate 1) "3"
Bolt (plate 1):
4 Nm (0.4 m•kg, 2.9 ft • lb)
To right protector "4".
Install the speed sensor lead so that its paint
"a" directs as shown and align the bottom "b" of
the plate 1 with the same paint.
6-33
FRONT FORK