Yamaha 2011 WR250FA Owner's Service Manual page 186

INSTALLING THE RIGHT CRANKCASE
COVER
1. Install:
• Dowel pin "1"
• O-ring "2"
• Collar "3"
• Gasket "4"
Apply the lithium soap base grease on the O-
ring.
2. Install:
• Right crankcase cover "1"
• Bolt (right crankcase cover) "2"
Bolt (right crankcase cover):
10 Nm (1.0 m•kg, 7.2 ft•lb)
• Apply the engine oil on the impeller shaft end.
• Mesh the impeller shaft gear "3" with primary
drive gear "4".
• Tighten the bolts in stage, using a crisscross
pattern.
OIL FILTER ELEMENT AND WATER PUMP
INSTALLING THE KICKSTARTER CRANK
1. Install:
• Kickstarter crank "1"
• Washer
• Bolt (kickstarter crank)
Install so that there is a clearance "a" of 13 mm
(0.51 in) or more between the kickstarter and
frame and that the kickstarter does not contact
the crankcase cover when it is pulled.
2. Install:
• Oil hose "1"
• Bolt (oil hose) "2"
5-53
Bolt (kickstarter crank):
33 Nm (3.3 m•kg, 24 ft•lb)
Bolt (oil hose):
8 Nm (0.8 m•kg, 5.8 ft•lb)