Accessories - Hilti DX462 Operating Instructions Manual

cant force. The tool can be fired only when pressed ful-
ly against the work surface in this way.
In addition, all Hilti DX tools are equipped with an unin-
tentional firing safety device
from firing if the trigger is pulled and the tool then pressed
against the work surface. The tool can be fired only when
it is first pressed (1.) against the work surface correct-
en
ly and the trigger then pulled (2.).
4. Cartridges, accessories and fasteners

Accessories

Ordering designation
Splinter guard
X-PT 460
Fastener guides
Ordering designation
X-462-F8
X-462-F8S12
Pistons
Ordering designation
X-462-P8
Fasteners
Ordering designation
X-U
X-C
X-S
X-CR
DS
X-SW
R23 / R36
X-HS / X-HS-W
X-CC / X-CW
X-(D)FB / X-EMTC
20
Printed: 08.07.2013 | Doc-Nr: PUB / 5069845 / 000 / 02
. This prevents the tool
5
Application
An additional baseplate that helps to keep the tool perpendicular when pressed
against the base material and to reduce splintering (for use with standard fastener
guide only).
Also known as the pole tool. An extension system for various applications on ceilings.
Application
Standard fastener guide.
Fastener guide for nails with a 12 mm steel washer for higher pull-over loads.
Application
Standard piston.
Application
High-strength nails for fastening to higher strength steel and concrete with a wide
varity of applications.
Nails with differing application profile for a wide variety of fastenings
Standard nails for efficient fastening to steel
Stainless-steel nails for fastenings in damp or corrosive surroundings
High-performance nail for general fastening on concrete and steel
Flexible washer fasteners for fastening insulating foils / sheeting to concrete and steel
Washers for Hilti nails: simple securing of joint seals, foils / sheeting and timber to
concrete and steel using the X-460 WH23/36 washer holder
Suspension system with threaded connection
Clip for securing suspended fastening systems using wires
Metal conduit clip for fastening conduits or cable ducts and insulated pipes (hot or
cold) for plumbing and heating
2
4
3
5
2
1