ZyXEL Communications P-660R-Tx v2 Series Support Notes page 63

Hide thumbs Also See for P-660R-Tx v2 Series:

Table of Contents

wan atm vchunt add <remoteNodeIndex> <vpi> <vci> <service

bit(hex)>

wan atm vchunt save

Note: <remote node> : input the remote node index 1-8

<vpi> : vpi value

<vci> : vci value

<service>: it's a hex value, bit0:PPPoE/VC (1), bit1:PPPoE/LLC (2) ,

bit2:PPPoA/VC (4), bit3:PPPoA/LLC (8), bit4:Enet/VC (16), bit5 :Enet/LLC (32)

For examples:

If you need service PPPoE/LLC and Enet/LLC then the service bits

will be 2+32 = 34 (decimal) = 22 (hex), you must input 22

If you want to enable all service for VC hunting, the service bits will be

1+2+4+8+16+32=63(decimal)= 3f (hex), you must input 3f

Need to perform save after this by command 'wan atm vchunt save'

(3) Delete items from the auto-haunting preconfigured table via command:

wan atm vchunt remove <remote node> <vpi> <vci>

• Using Zero configuration.

(1) After configure the auto-haunting preconfigured table. You just need a PC

connected to the device LAN Ethernet port with the DSL sync up.

P-660R-Tx v2 Series Support Notes

Table of Contents