Set Up Your Workstation; Set Up Your P-660R-Tx V2 - ZyXEL Communications P-660R-Tx v2 Series Support Notes

P-660R-Tx v2 Series Support Notes

Set up your workstation

(1) Ethernet connection
Connect the LAN ports of all computers and the P-660R-Tx v2 to a HUB using
a straight Ethernet cable.
(2) TCP/IP configuration
Since the P-660R-Tx v2 is set to DHCP server as default, so you need only to
configure the workstations as the DHCP clients in the networking settings. In
this case, the IP address of the computer is assigned by the P-660R-Tx v2.
The P-660R-Tx v2 can also provide the DNS to the clients via DHCP if it is
available. For this setup in Windows, we check the option 'Obtain an IP
address automatically' in its TCP/IP setup. Please see the example shown
below.

Set up your P-660R-Tx v2

The following procedure shows you how to configure your P-660R-Tx v2 as
Router mode for routing traffic. We will use SMT menu to guide you through
the related menu. You can use console or Telnet for finishing these
configurations.
20
All contents copyright © 2006 ZyXEL Communications Corporation.