ZyXEL Communications P-660R-Tx v2 Series Support Notes page 60

wan node callsch [index#]
wan node save
For example, if we want to apply the call schedule set 1 to remote node 1, we
could use the commands:
wan node index
wan node callsch
wan node save
• Time Service in P-660R-Tx v2
There is no RTC (Real-Time Clock) chip so the P-660R-Tx v2 should launch a
mechanism to get current time and date from external server in boot time.
Time service is implemented by the Daytime protocol(RFC-867), Time
protocol(RFC-868), and NTP protocol(RFC-1305). You have to assign an IP
address of a time server and then, the P-660R-Tx v2 will get the date, time,
and time-zone information from this server. You can configure it in Web
Configurator, Advanced Setup -> Time and Date.
All contents copyright © 2006 ZyXEL Communications Corporation.
1
1
P-660R-Tx v2 Series Support Notes
60