General Faq; How Can I Manage P-660R-Tx V2; What Is The Default Password To Loging Web Configurator; How Do I Know The P-660R-Tx V2'S Wan Ip Address Assigned By The Isp - ZyXEL Communications P-660R-Tx v2 Series Support Notes

Hide thumbs Also See for P-660R-Tx v2 Series:

Table of Contents

General FAQ

Web configurator

CLI (Command Line Interface)

Telnet remote management

TFTP (Trivial File Transfer Protocol) and FTP firmware upgrade and

configuration backup and restore

The default password is '1234'. You can change the password when login to

web configurator in the Advanced Setup->Password.

Please record your new password whenever you change it. The system

will lock you out if you have forgotten your password.

3. How do I know the P-660R-Tx v2's WAN IP address assigned by the

ISP?

You can view "My WAN IP <from ISP> : 200.1.1.1" shown in Web

Configurator, Maintenance -> System Status -> WAN Information to check

this IP address.

Generally, the voice band uses the lower frequency ranging from 0 to 4KHz,

while ADSL data transmission uses the higher frequency. The micro filter acts

as a low-pass filter for your telephone set to ensure that ADSL transmissions

do not interfere with your voice transmissions. For the details about how to

connect the micro filter please refer to the user's manual.

5. The P-660R-Tx v2 supports Bridge and Router mode, what's the

difference between them?

When the ISP limits some specific computers to access Internet, that means

only the traffic to/from these computers will be forwarded and the other will be

filtered. In this case, we use bridge mode which works as an ADSL modem to

connect to the ISP. The ISP will generally give one Internet account and limit

only one computer to access the Internet.

For most Internet users having multiple computers want to share an Internet

account for Internet access, they have to add another Internet sharing device,

P-660R-Tx v2 Series Support Notes

Table of Contents