Refrigeration; Adjusting Door And Replacing Hinges - Master Bilt CMICL-156 Installation And Operation Manual

4. Using the same procedure as above continue with the installation of the remaining corner panels.
5. Place a carpenter's level against the face of the door frame to ensure correct vertical alignment and latch
the door frame to the roof panel while holding level in place.
6. Adjust the bottom wiper gasket of the door to the point that it sweeps the finished floor when the door is in
the fully closed position. (Note: do not adjust the wiper gasket so far downs that it prevents the door
from closing property.)
7. Before securing the panels to the floor, double check the door frame alignment by placing a carpenter's
level vertically against each door frame leg.
8. Connect correctly fused 120Volts-service line to the J-box by the light fixture on the interior of the walk-in.

REFRIGERATION

NOTE: Wiring diagrams are located inside pre-wired electrical panel on the condensing unit.
Be sure electrical service is the same as the electrical characteristics on the compressor data plate. Connect
correctly fused service line to the service line J-box on the condensing unit.
After routing condensate line with standard trap from drain pan of evaporator coil, seal around drain line with
silicone or butyl caulking to prevent moist air entering box from outside.
Start compressor and allow running at least 24 hours before committing product into the walk-in. This 24
hours period should be a testing period to check temperature-holding range versus the temperature control
setting. On low temperature units, check the defrost control system to see that all ice is removed from the coil
during each defrost period. In addition all checks of door operation and all other component operation should
be checked.

ADJUSTING DOOR AND REPLACING HINGES

NOTE: all Master-Bilt swing doors are provided with adjustable back-up plates in the door for hinge
adjustment.
1. Place shims under door ( See Figure #9)
2. Loosen to adjust or remove to replace those screws that attach hinge blade to door. When adjusting door
hinges do not screws fastening hinge to frame of door.'
3. Shim under door as necessary to provide a ¼" space between top of door and the door frame to ensure
square fit( See Figure #9)
4. Tighten or reinstall screws attaching the hinge blade to the door.
5. The following procedure should be followed if one or all hinges are replaced.
6. After adjusting or replacing the hinges, remove shims and check the space at the top of the door
periodically for proper alignment.
11