Table of Contents
Related Manuals for Master Bilt SPT-28
Summary of Contents for Master Bilt SPT-28
- Page 1 Sandwich Salad Unit Undercounter Refrigerator, Freezer Installation and Operation Manual Please read this manual completely before attempting to install or operate this equipment! SPT-28, SPT-48, SPT-72 UC-28SR, UC-48DR, UC-72TR Full Stainless Steel Visible Exterior...
-
Page 2: Table Of Contents
9. BEFORE REQUESTING SERVICE ............. 8 10. WARRANTY ..................9~11 SPECIFICATION Sandwich Salad Unit MODEL COMP H.P. V/Hz REFRIGERANT AMPS WEIGHT SPT-48 115V/60Hz R-134a 5.0A 180lbs SPT-28 115V/60Hz R-134a 5.5A 128lbs SPT-72 115V/60Hz R-134a 10.8A 385lbs Undercounter Refrigerator MODEL COMP H.P. V/Hz REFRIGERANT... -
Page 3: Installation Of Handle
4. INSTALLATION OF CASTOR AND CASTOR BRAKE 1) Screw the castor (in rear side) and the castor brakes (in front side) by using castor wrench. 2) Use the castor shims to level the cabinet, if necessary, by inserting them to stems of the castors. Master bilt... -
Page 4: How To Clean The Pan Supporter
5. HOW TO CLEAN THE PAN SUPPORTER Guide Pan Drain Pan MODEL: SPT-28 SPT-48 SPT-72 1) Remove the Guide Pans and Pans. Then pull out the Pan Supporter. Clean the pan supporter and reinstall in place. Master bilt... -
Page 5: Installation
5. STABILIZING - Make sure the unit is installed in a stable condition with the front wheels locked while in use. 6. LEVELING - Be sure that the unit is level from front to back and side to side. Master bilt... -
Page 6: Cleaning & Caution
- Turn ‘off’ the power switch before disconnecting the power cord, whenever performing maintenance functions or cleaning the refrigerated cabinet. - Compressor warranties are void if compressor burns out due to low voltage. 2. RE-STARTING - If disconnected, wait 5 minutes before re-starting. Master bilt... -
Page 7: Basic Operation
BASIC OPERATION SPT-28, SPT-48, SPT-72 UC-28SR, UC-48DR, UC-72TR 1. The controller(thermostat) is located at the top inside of the unit. 2. The factory setting for the control is ‘Normal’. 3. Setting toward “Cool” for higher temperature and “Cold” for lower temperature. -
Page 8: Before Requesting Service
• The door gasket has come out. The following points are not malfunctions: • A water-flowing sound can be heard when the compressor stops. This is the sound of REFRIGERANT flowing. • The compressor does not run during the defrost cycle. Master bilt... -
Page 9: Warranty
Micron level vacuums must be achieved to insure low moisture levels in the system. 500 microns or lower must be obtained. When compressor is grounded, suction filter drier and 620 drier or better must be replaced. Compressor must be obtained through Turbo Air Inc., unless otherwise specified in writing, through Turbo Air’s warranty department. Master bilt... - Page 10 OUTSIDE U.S. AND CANADA: This warranty does not apply to, and Turbo Air is not responsible for, any warranty claims made on products sold or used outside the United State and Canada. CHANGES MADE TO WARRANTY COMMENCED ON 5/1/2002 Master bilt...
- Page 11 908 Highway 15 North • New Albany, MS 38652 Phone: (662)534-9061•Toll-Free: 800-647-1284 FAX: (662)534-6049•Toll-Free: 800-232-3966 www.master-bilt.com Master bilt...