Honda F220 Owner's Manual page 22

OPERATION
Tilling Depth Adjustment
The drag bar is used to control the
tilling depth, which can be
adjusted by removing the pin and
retainer and sliding the drag bar
up and down as necessary.
During operation, if the machine
jerks forward while tilling, press
down on the handlebars. This will
cause the drag bar to dig more
deeply into the soil.
Front Wheel
After getting to the tilling site, move the front wheel to the raised
position before tiling. Always stop the engine before lowering or raising
the wheel.
To raise or lower the wheel, pull out the wheel assembly, move the
wheel, and then release the wheel assembly.
20
RETAINER
PIN
TILLING POSITION
TRANSPORT POSITION
FRONT WHEEL
DRAG BAR