Step 7 - Operating Your Hunter Fan; Step 9 - Installing Light Fixture - Hunter Installer's Choice Installation And Operation Manual

STEP 8 - OPERATING YOUR HUNTER FAN
1. Turn on electrical power to the fan.
2. The pull chain controls power to the fan. The chain has four settings in sequence: High, Medium, Low and Off.
• Pull the chain slowly to change settings.
• Release slowly to prevent the chain from recoiling into the blades.
• The chain uses a breakaway connector that separates if the chain is jerked. If this happens, simply reinsert the
chain into the connector.
3. Ceiling fans work best by blowing air downward (counterclockwise blade rotation) in warm weather to cool the
room with a direct breeze. In winter, having the fan draw air upward (clockwise blade rotation) will distribute
the warmer air trapped at the ceiling around the room without causing a draft.
To change the direction of air flow, turn the fan off and let it come to a complete stop. Slide the reversing switch
on the fan to the opposite position as shown in Figure 8b. Restart fan.
4. If your fan wobbles when operating, use the enclosed balancing kit and instructions to balance the fan.
Figure 8a - Air Flow Patterns

STEP 9 - INSTALLING LIGHT FIXTURE

Your Hunter fan may include an integrated light fixture. If you are not installing a light fixture, turn directly to
OPERATING YOUR HUNTER FAN for additional instructions.
Information for wiring and installing all included Hunter light fixtures are included in the following section "Attach-
ing Light Fitter to Switch Housing," .
ATTACHING LIGHT FITTER TO SWITCH HOUSING
Note: Refer to Figures 9a and 9b for the steps below.
1. Remove the switch housing cover from the switch housing by removing the three #6-32 housing assembly
screws from the sides of the switch housing. See Figure 9b.
Note: Do not discard the screws or cap. You will need the screws later in the installation. You will need the cap
if you remove the light fixture in the future.
Figure 9a - Fan Switch Housing
41473-01 12/6/2001
Pull
Chain
Figure 8b - Pull Chain and Reversing
Switch
Figure 9b - Removing Switch Housing
Cover
Reversing
Switch
Switch
Housing
Housing
Assembly
Screw
Switch
Housing
Cover
11